Hi Guys,
I need a bit of support, and thanks in advance.
I have had nothing but trouble with my dLink camera setup, but finally got it working with only the occasional drop out. A few weeks later all cameras disconnected, I tried setting them all up again, and factory resetting the NVR (DNR-322L)with no luck. After checking everything I could I found that when the camera's were added to the NVR they were only their own channel 1, 2, 3 or 4 respectively. However once I close the set up, they all revert back to channel 1, and only one camera works. When I try and change the channel back their is only the option of channel 1.
And if anyone can assist with something more than 'turn it off, and turn it back on', or 'get a pen, and find the small button on the back, press that button for at least 10 seconds' that would be greatly appreciated.
I need a bit of support, and thanks in advance.
I have had nothing but trouble with my dLink camera setup, but finally got it working with only the occasional drop out. A few weeks later all cameras disconnected, I tried setting them all up again, and factory resetting the NVR (DNR-322L)with no luck. After checking everything I could I found that when the camera's were added to the NVR they were only their own channel 1, 2, 3 or 4 respectively. However once I close the set up, they all revert back to channel 1, and only one camera works. When I try and change the channel back their is only the option of channel 1.
And if anyone can assist with something more than 'turn it off, and turn it back on', or 'get a pen, and find the small button on the back, press that button for at least 10 seconds' that would be greatly appreciated.
