Hi,
Needing a little bit of help. I've got a XenServer which one of the VM's has a virtual VLAN adapter running on VLAN 7. I'd like to enable on our Netgear Prosafe switch to have that link from the server access the network, and the VLAN from the VM only access another device on VLAN 7..
In a little more detail this is the setup..
We have Kerio Control running in a XenServer VM.
The server has two physical network interfaces, eth0 goes directly to a modem/router. eth1 goes to the LAN.
I can create a VLAN adapter in Kerio (which I've done) which is on eth1. I'd like that VLAN to go to our secondary modem/router as a failover connection in kerio rather than connecting to the LAN at all..
the secondary modem/router cannot have ANY access to the LAN, just the VLAN7. I've tried setting up tagged and untagged ports in the switch but to be honest, I haven't really played around with VLAN's and am unable to get the setup to work..
Suggestions?
Needing a little bit of help. I've got a XenServer which one of the VM's has a virtual VLAN adapter running on VLAN 7. I'd like to enable on our Netgear Prosafe switch to have that link from the server access the network, and the VLAN from the VM only access another device on VLAN 7..
In a little more detail this is the setup..
We have Kerio Control running in a XenServer VM.
The server has two physical network interfaces, eth0 goes directly to a modem/router. eth1 goes to the LAN.
I can create a VLAN adapter in Kerio (which I've done) which is on eth1. I'd like that VLAN to go to our secondary modem/router as a failover connection in kerio rather than connecting to the LAN at all..
the secondary modem/router cannot have ANY access to the LAN, just the VLAN7. I've tried setting up tagged and untagged ports in the switch but to be honest, I haven't really played around with VLAN's and am unable to get the setup to work..
Suggestions?