Cisco ASA 5510 on home network

Trying to setup a home network using an HP procurve 2910al a 2008 r2 domain controller and a cisco 5510 asa, the asa is hooked to my linksys home wifi router which is hooked to my cable modem, that is the outside interface. I can ping out from the asa, but I cannot get my pc to talk through the asa. I don't even see the messages in the log that it is trying to go out over port 80, and my network connection says no internet access. Below is the config from my ASA. What am I doing wrong here?

Result of the command: "sh run"

: Saved
:
ASA Version 8.0(4)
!
hostname ciscoasa
domain-name contoso.com
enable password 2KFQnbNIdI.2KYOU encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
dns-guard
!
interface Ethernet0/0
nameif inside
security-level 100
ip address 10.0.0.2 255.255.255.0
!
interface Ethernet0/1
nameif outside
security-level 0
ip address dhcp setroute
!
interface Ethernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/3
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
nameif management
security-level 100
ip address 172.16.0.1 255.255.255.0
management-only
!
boot system disk0:/asa804-k8.bin
ftp mode passive
dns domain-lookup inside
dns domain-lookup outside
dns server-group DefaultDNS
name-server 8.8.8.8
name-server 4.2.2.2
domain-name contoso.com
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
object-group service DM_INLINE_TCP_1 tcp
port-object eq www
port-object eq https
access-list inside_access_in extended permit tcp 10.0.0.0 255.255.255.0 any object-group DM_INLINE_TCP_1 log disable
access-list inside_access_in extended permit icmp 10.0.0.0 255.255.255.0 any log disable
access-list outside_access_in extended permit ip any any log disable
pager lines 24
logging enable
logging asdm informational
mtu inside 1500
mtu outside 1500
mtu management 1500
no failover
icmp unreachable rate-limit 1 burst-size 1
asdm image disk0:/asdm-615.bin
no asdm history enable
arp timeout 14400
global (outside) 101 interface
nat (inside) 101 0.0.0.0 0.0.0.0
access-group inside_access_in in interface inside
access-group outside_access_in in interface outside
route outside 0.0.0.0 0.0.0.0 192.168.1.0 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
dynamic-access-policy-record DfltAccessPolicy
aaa authentication http console LOCAL
aaa authentication ssh console LOCAL
http server enable
http 192.168.1.0 255.255.255.0 management
http 10.0.0.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
telnet timeout 5
ssh 10.0.0.0 255.255.255.0 inside
ssh timeout 5
console timeout 0
dhcp-client client-id interface outside
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
username cisco password XCGrUhS7v.ZtgAWB encrypted privilege 15
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map global_policy
class inspection_default
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:df34fedd93207c6885b3c0284a4237ea
: end