I have setup a wireless network for a client. There phones connect, there laptops connect and 1 Ipad will connect. They have three new Ipads that will show connected but won't browse.
When you click Safari it opens 1/4 of the way and then does not go any further. It should be noted that I checked the IP addresses and they are good and connected.
I can see the devices listed in the wap. As I troubleshooting measure I replaced the first wireless device a Linksys EA2700 (setup as an access point only) with a Ubiquiti wap. Still no luck. Also it should further be noted that there were only a few devices connected. I also tried connecting to only the guest network and they would connect but not browse. Any ideas or suggestions would be great.
These devices were able to connect outside of the office and at the apple store. The apple store reset the devices to the factory default settings and still no luck.
Any Ideas?
When you click Safari it opens 1/4 of the way and then does not go any further. It should be noted that I checked the IP addresses and they are good and connected.
I can see the devices listed in the wap. As I troubleshooting measure I replaced the first wireless device a Linksys EA2700 (setup as an access point only) with a Ubiquiti wap. Still no luck. Also it should further be noted that there were only a few devices connected. I also tried connecting to only the guest network and they would connect but not browse. Any ideas or suggestions would be great.
These devices were able to connect outside of the office and at the apple store. The apple store reset the devices to the factory default settings and still no luck.
Any Ideas?