Hi,
I bought a new router to connect to my cable modem, so that I could share through USB. It's a Netgear WNR2200, the N300 range. I was trying to find out how to set the two of them up, and stupidly followed the wrong instructions, setting the IP address to 192.168.1.100. (yes I've tried typing that into browser, tried typing the old one, tried routerlogin.net and .com. Then I tried resetting the network adapter (following threads by people who had the same problem) by doing the following in elevated command prompt:
ipconfig /flushdns
nbtstat -R
nbtstat -RR
netsh int reset all
netsh int ipv4 reset
netsh int ipv6 reset
netsh winsock reset
And then a reboot.
I've tried resetting the router, by holding the pin in and letting the test light flash for a good 20-30 seconds. I've tried turning it off, waiting, turning back on. I've tried restarting in safe mode.
What can I do to connect to this router again so I can restore the proper IP? I don't have another laptop I can use.
I bought a new router to connect to my cable modem, so that I could share through USB. It's a Netgear WNR2200, the N300 range. I was trying to find out how to set the two of them up, and stupidly followed the wrong instructions, setting the IP address to 192.168.1.100. (yes I've tried typing that into browser, tried typing the old one, tried routerlogin.net and .com. Then I tried resetting the network adapter (following threads by people who had the same problem) by doing the following in elevated command prompt:
ipconfig /flushdns
nbtstat -R
nbtstat -RR
netsh int reset all
netsh int ipv4 reset
netsh int ipv6 reset
netsh winsock reset
And then a reboot.
I've tried resetting the router, by holding the pin in and letting the test light flash for a good 20-30 seconds. I've tried turning it off, waiting, turning back on. I've tried restarting in safe mode.
What can I do to connect to this router again so I can restore the proper IP? I don't have another laptop I can use.
